CWE-1234: Hardware Internal or Debug Modes Allow Override of Locks
Weakness ID: 1234
Vulnerability Mapping:
ALLOWEDThis CWE ID may be used to map to real-world vulnerabilities Abstraction: BaseBase - a weakness that is still mostly independent of a resource or technology, but with sufficient details to provide specific methods for detection and prevention. Base level weaknesses typically describe issues in terms of 2 or 3 of the following dimensions: behavior, property, technology, language, and resource.
View customized information:
For users who are interested in more notional aspects of a weakness. Example: educators, technical writers, and project/program managers.For users who are concerned with the practical application and details about the nature of a weakness and how to prevent it from happening. Example: tool developers, security researchers, pen-testers, incident response analysts.For users who are mapping an issue to CWE/CAPEC IDs, i.e., finding the most appropriate CWE for a specific issue (e.g., a CVE record). Example: tool developers, security researchers.For users who wish to see all available information for the CWE/CAPEC entry.For users who want to customize what details are displayed.
×
Edit Custom Filter
Description
System configuration protection may be bypassed during debug mode.
Extended Description
Device configuration controls are commonly programmed after a device power reset by a trusted firmware or software module (e.g., BIOS/bootloader) and then locked from any further modification. This is commonly implemented using a trusted lock bit, which when set, disables writes to a protected set of registers or address regions. The lock protection is intended to prevent modification of certain system configuration (e.g., memory/memory protection unit configuration). If debug features supported by hardware or internal modes/system states are supported in the hardware design, modification of the lock protection may be allowed allowing access and modification of configuration information.
Common Consequences
This table specifies different individual consequences associated with the weakness. The Scope identifies the application security area that is violated, while the Impact describes the negative technical impact that arises if an adversary succeeds in exploiting this weakness. The Likelihood provides information about how likely the specific consequence is expected to be seen relative to the other consequences in the list. For example, there may be high likelihood that a weakness will be exploited to achieve a certain impact, but a low likelihood that it will be exploited to achieve a different impact.
Scope
Impact
Likelihood
Access Control
Technical Impact: Bypass Protection Mechanism
Bypass of lock bit allows access and modification of system configuration even when the lock bit is set.
High
Potential Mitigations
Phases: Architecture and Design; Implementation; Testing
Security Lock bit protections should be reviewed for any bypass/override modes supported.
Any supported override modes either should be removed or protected using authenticated debug modes.
Security lock programming flow and lock properties should be tested in pre-silicon and post-silicon testing.
Effectiveness: High
Relationships
This table shows the weaknesses and high level categories that are related to this weakness. These relationships are defined as ChildOf, ParentOf, MemberOf and give insight to similar items that may exist at higher and lower levels of abstraction. In addition, relationships such as PeerOf and CanAlsoBe are defined to show similar weaknesses that the user may want to explore.
Relevant to the view "Research Concepts" (CWE-1000)
Nature
Type
ID
Name
ChildOf
Class - a weakness that is described in a very abstract fashion, typically independent of any specific language or technology. More specific than a Pillar Weakness, but more general than a Base Weakness. Class level weaknesses typically describe issues in terms of 1 or 2 of the following dimensions: behavior, property, and resource.
This table shows the weaknesses and high level categories that are related to this weakness. These relationships are defined as ChildOf, ParentOf, MemberOf and give insight to similar items that may exist at higher and lower levels of abstraction. In addition, relationships such as PeerOf and CanAlsoBe are defined to show similar weaknesses that the user may want to explore.
Relevant to the view "Hardware Design" (CWE-1194)
Nature
Type
ID
Name
MemberOf
Category - a CWE entry that contains a set of other entries that share a common characteristic.
The different Modes of Introduction provide information about how and when this weakness may be introduced. The Phase identifies a point in the life cycle at which introduction may occur, while the Note provides a typical scenario related to introduction during the given phase.
Phase
Note
Architecture and Design
Implementation
Applicable Platforms
This listing shows possible areas for which the given weakness could appear. These may be for specific named Languages, Operating Systems, Architectures, Paradigms, Technologies, or a class of such platforms. The platform is listed along with how frequently the given weakness appears for that instance.
Languages
Class: Not Language-Specific (Undetermined Prevalence)
Operating Systems
Class: Not OS-Specific (Undetermined Prevalence)
Architectures
Class: Not Architecture-Specific (Undetermined Prevalence)
Technologies
Class: Not Technology-Specific (Undetermined Prevalence)
Demonstrative Examples
Example 1
For example, consider the example Locked_override_register example. This register module supports a lock mode that blocks any writes after lock is set to 1.
However, it also allows override of the lock protection when scan_mode or debug_unlocked modes are active.
end
else if (write & (~lock_status | scan_mode | debug_unlocked) ) // Register protected by Lock bit input, overrides supported for scan_mode & debug_unlocked
begin
Data_out <= Data_in;
end
else if (~write)
begin
Data_out <= Data_out;
end
endmodule
If either the scan_mode or the debug_unlocked modes can be triggered by software, then the lock protection may be bypassed.
(good code)
Either remove the debug and scan mode overrides or protect enabling of these modes so that only trusted and authorized users may enable these modes.
Example 2
The following example code [REF-1375] is taken from the register lock security peripheral of the HACK@DAC'21 buggy OpenPiton SoC. It demonstrates how to lock read or write access to security-critical hardware registers (e.g., crypto keys, system integrity code, etc.). The configuration to lock all the sensitive registers in the SoC is managed through the reglk_mem registers. These reglk_mem registers are reset when the hardware powers up and configured during boot up. Malicious users, even with kernel-level software privilege, do not get access to the sensitive contents that are locked down. Hence, the security of the entire system can potentially be compromised if the register lock configurations are corrupted or if the register locks are disabled.
(bad code)
Example Language: Verilog
...
always @(posedge clk_i)
begin
if(~(rst_ni && ~jtag_unlock && ~rst_9))
begin
for (j=0; j < 6; j=j+1) begin
reglk_mem[j] <= 'h0;
end
end
...
The example code [REF-1375] illustrates an instance of a vulnerable implementation of register locks in the SoC. In this flawed implementation [REF-1375], the reglk_mem registers are also being reset when the system enters debug mode (indicated by the jtag_unlock signal). Consequently, users can simply put the processor in debug mode to access sensitive contents that are supposed to be protected by the register lock feature.
This can be mitigated by excluding debug mode signals from the reset logic of security-critical register locks as demonstrated in the following code snippet [REF-1376].
(good code)
Example Language: Verilog
...
always @(posedge clk_i)
begin
if(~(rst_ni && ~rst_9))
begin
for (j=0; j < 6; j=j+1) begin
reglk_mem[j] <= 'h0;
end
end
...
Memberships
This MemberOf Relationships table shows additional CWE Categories and Views that reference this weakness as a member. This information is often useful in understanding where a weakness fits within the context of external information sources.
Nature
Type
ID
Name
MemberOf
Category - a CWE entry that contains a set of other entries that share a common characteristic.
(this CWE ID could be used to map to real-world vulnerabilities)
Reason: Acceptable-Use
Rationale:
This CWE entry is at the Base level of abstraction, which is a preferred level of abstraction for mapping to the root causes of vulnerabilities.
Comments:
Carefully read both the name and description to ensure that this mapping is an appropriate fit. Do not try to 'force' a mapping to a lower-level Base/Variant simply to comply with this preferred level of abstraction.